DeadBand/Limiter mix

DeadBand and Rate Limiter:

Implementation of a linear mapping of an input x to an output y

with the input x between xmin and xmax and output y between 0 and 100%

on both sides of the center position of the input

xmin and xmax adjustable in-flight by any control source

so:

y = sign(x)* minimum(xmax, maximum(xmin, ( (abs(x)-xmin) * 100%/(xmax-xmin) )  )

To be used to create a dead band (zero output y) for any input abs(x) smaller than xmin

and limit the output y to 100% for any input abs(x) greater then xmax

and have a linear interpolation between these two endpoints (xmin,0) and (xmax,100)

Source x to be provided in the script setup:        i.e. snapflap -> choose stick ele (raw) or input ele

Source to be provided to supply xmin:               to allow in flight adaptation through i.e. slider S1.

Source to be provided to supply xmax:               to allow in flight adaptation through i.e. slider S2.

Value xminv will override the xmin source value:    set to -1 to disable value override.

Value xmaxv will override the xmax source value:    set to -1 to disable value override.

Output y is provided as output

To check the correct function and settings:

Source x is provided as output 

xmin is provided as output

xmax is provided as output