Slash 4x4

  • This is a basic setup to run a 2channel Slash 4x4 with a X series RX. It's setup with throttle hold and the Throttle and Steering on the right stick. If you move SC to the lower position it moves throttle to the left stick incase you want to use both sticks.

    Also set up to use a FLVS to check voltage on the battery and automatically call out voltage if it's below a certain point. Also if you have the GPS and are above a certain speed it will read off that voltage for you.

  • Taranis X9D(+), X9E download: Previous versions Slash_4x4.bin 0.28 Kb 1890
    Filename Version File size Changes
    Slash_4x4.bin 1.0 0.28 Kb
  • Firmware compatibility: 2.0
  • Device Compatibility: Taranis X9D(+)
  • Author: tonkajeep34
  • E-mail or Website: https://rcsettings.com/index.php/viewdownload/5-ground-vehicles/201-slash-4x4
  • License: Other
  • Comments:
  • Throttle: Speed
  • Ailerons: Steering
  • Elevator: (Speed)
  • SC: switch speed from right to left stick
  • SH: throttle cut
  • Servo1: Engine Power
  • Servo2: Direction